- Remove forward and back sections of system of production of the fulfilled gases.
- Remove forward and back driveshafts (see. Removal and installation of driveshafts) — at once after removal of a back shaft muffle an opening of a back epiploon in order to avoid hit in dirt assembly. Try not to damage an epiploon, walls of its landing nest and a pin of a sliding collar.
- Disconnect electroconducting of sensors switches of provisions (N-4LO and ATR) and switchings of modes of a transfer case, the forward sensor of turns, and the executive electromotor.
|
- Disconnect a control lever switching from the external executive lever.
|
|
- Prop up a transfer case a transmission jack.
|
|
- Release fixture and separate a box from AT assembly.
|
|
- Installation is made upside-down. Track, that all fixture was tightened with demanded effort.
|
|
