Infiniti QX4 service since 1996 of release
	1. Introduction
	2. Maintenance instruction
	3. Routine maintenance
	4. Engine
	5. Cooling and heating systems
	6. Power supply systems and managements
	7. Start and charge systems
	8. Transmission line
		8.1. 4-step automatic transmission
			8.1.1. General information
			8.1.2. AT problem diagnostics - the general information
			8.1.3. Electronic and hydraulic control system of 4-step AT
			8.1.4. Removal and transmission installation
			8.1.5. Replacement of an epiploon of lengthening of transmission
			8.1.6. Removal and installation of a cooler of ATF
			8.1.7. Removal and installation of klapanny assembly of a hydraulic contour of management of AT
			8.1.8. Removal, check of a condition and installation of a driving cable of blocking of switchings
			8.1.9. Adjustment of a drive of switching of AT
			8.1.10. Adjustment of the sensor switch of provisions of AT / permission of start
			8.1.11. Major maintenance of AT
		8.2. Transfer case
		8.3. Differentials, power shafts / semi-axis
		8.4. Driveshafts
	9. Brake system
	10. Suspension bracket and steering
	11. Body
	12. Electric equipment

8-1-10-regulirovka-datchika-vyklyuchatelya-polozhenijj-at-razresheniya-zapuska.html

8.1.10. Adjustment of the sensor switch of provisions of AT / permission of start

PERFORMANCE ORDER

Disconnect driving draft from the lever a shaft of manual switching of AT. Transfer the lever of a shaft of manual switching to the situation "N".
Release fixture of the sensor switch of permission of start.
Pass a suitable pin through an opening in the lever of a shaft of manual switching and the sensor switch of permission of start — the lever should occupy closer to vertical situation.
Establish into place acting in film components and check serviceability of functioning of the sensor switch of permission of start — start of transmission should be carried out only in the positions "R" or "N" of the lever of the selector.