|
10-12-snyatie-i-ustanovka-komponentov-i-sborki-zadnejj-podveski.html
10.12. Removal and installation of components and assembly of a back suspension bracket The general design of a back suspension bracket — cм. illustration Design of a back suspension bracket.
Details of installation of elements of a back suspension bracket on the car
|
|
- Before starting an otpuskaniye of fixture of components, prop up assembly of the back bridge by a telezhechny jack, having enclosed on its head the wooden block.
- Having hung out a suspension bracket, disconnect from brake boards hydraulic brake lines and cables of a drive of the parking brake.
|
|
In order to avoid a rounding off шлицов cap shtutserny nuts use a special cap natural a cutting head. Remove from a suspension bracket wheel ABS sensors and take them aside together with the connected electroconducting. |
- Release fixture of collars of fastening of a bar of the back stabilizer of cross-section stability to a body.
- Give fixture and disconnect from the car bottom the top and bottom levers of a suspension bracket.
- Disconnect the driveshaft from the main transfer of the back bridge.
- Give nuts of fastening of the top support of back shock-absorbers.
- In case of need remove from assembly components needing replacement.
- Installation is made upside-down.
|
|
|
|
|
|
The final tightening of fixture of the elements equipped with rubber plugs is made in the unloaded condition with the wheels lowered on the earth. |
|
|
|
